英语翻译The ring travel area is defined as the area from the crown of the cylinder bore to 5/16” below the bottom of exhaust port towards cylinder mounting flange.The cylinder in the ring travel area must not have a radial rate of change in exc

英语翻译The ring travel area is defined as the area from the crown of the cylinder bore to 5/16” below the bottom of exhaust port towards cylinder mounting flange.The cylinder in the ring travel area must not have a radial rate of change in exc
英语翻译
The ring travel area is defined as the area from the crown of the cylinder bore to 5/16” below the bottom of exhaust port towards cylinder mounting flange.The cylinder in the ring travel area must not have a radial rate of change in excess of 0.0001 in 15 degrees nor accumulate to a rate of change in excess of 0.0003 in 90 degrees.
The cylinder bore must not be out-of-round in excess of 0.0005 extending from the crown to the top of the exhaust port.From the bottom of the ring travel area to the cylinder skirt,the bore may tape an additional 0.0005 inches larger only.
The bore shall be straight and perpendicular to the flange as specified on the applicable drawing.Deviation of any element of the cylinder from a straight line shall not be at a rate greater than 0.0004 per inch and shall not accumulate to more than 0.0005”.
The application of the chromium deposition shall be in a continuous operation.Double plating is not allowed.The chromium deposit shall be homogeneous,uniform in appearance and free from pits,nodules,blisters and defects except as specifically permitted by this specification.
Cylinders shall be cleaned after all mechanical operations (such as grinding,honing,deburring,etc) to remove all residue from those operations,and/or chromium cracked or loosened during those operations.Cylinders must be clean and free from extraneous materials that could cause premature scuffing or wear or pistons or rings or that could be otherwise detrimental to engine operation.

英语翻译The ring travel area is defined as the area from the crown of the cylinder bore to 5/16” below the bottom of exhaust port towards cylinder mounting flange.The cylinder in the ring travel area must not have a radial rate of change in exc
环形旅游区是指面积从官方的口径汽缸5/16"以下 汽缸底部安装排气法兰走向. 气缸的环形旅游区不能有径向变动超过于0.0001 15度,也积累了变动超过90度0.0003. 气缸口径不可乱了一轮超过从0.0005延伸到顶部的皇冠 排气. 从内心圈外旅游区的圆筒裙、 磁带的额外负担可能较大,只有0.0005英寸. 并应当承担的直线垂直于法兰指定适用于绘画. 任何偏差来自元素的直线气缸的速度不得大于0.0004 每英寸不得累积超过0.0005". 应用沉积铬应在连续运行. 双镀不得. 铬存款应均匀,外观均匀且无孔,结节 水泡和缺陷除明确允许这种规格. 毕竟分销商必须清洗机械作业(如研磨、珩磨、毛刺、 等),以清除所有这些行动废渣和/或在这些行动中铬破获或松动. 气瓶必须清正不受外在物质可能导致早产或活塞磨损或咬死或戒指 否则可能损害或发动机运行.